EdilKamin KIKKA 8 Installation, Usage Et Maintenance page 33

fi g. 1
A
fi g. 3
D
fi g. 5
C
fi g. 7
INSTALLATION
B
fi g. 2
C
fi g. 4
E
fi g. 6
fi g. 8
SMOKE OUTPUT
KIKKA is designed for the connection of the fl ue at the top,
back or side left of the stove.
The stove is delivered ready for the ouput of the fl ue from the
back (fi g. 1).
The stove is delivered with the fl ue exit set from the backside
(fi g.2)
TO INSTALL THE FLUE IN THE OTHER AVAILABLE
WAYS IT IS NECESSARY TO REMOVE THE LEFT
METAL SIDE
To connect:
- Remove the left metal side by the 3 screws on the back (B –
fi g.2)
At this point, choose the necessary fl ue connection.
SIDE SMOKE OUTPUT CONNECTION
Install the junction by the band supplied on the fl ue pipe (C –
fi g.4) and connect the fl ue pipe (optional – fi g.4)
Remove the pre-cut diaphragm from the sheet metal side to al-
low the smoke output pipe (not provided) to pass through (fi g.
4).
Complete the operation by applying the closure rosette pro-
vided (D - fi g. 5) using the screws provided, after replacing the
metal side.
N.B. The rosette and the metal side must be fi tted after the fl ue
has been defi nitively fi xed.
TOP SMOKE OUTPUT CONNECTION
Remove the metal cover (E – fi g.6)
Fit the elbow connection to the smoke extractor unit vent (C-
fi g. 7) with the band provided.
Connect the smoke output pipe (not provided) to the aforesaid
elbow joint.
AFTER COMPLETING THE CONNECTION OF THE
SMOKE OUTPUT PIPE TO THE FLUE, REPLACE THE
METAL SIDE.
- 33
-