Maintenance And Cleaning; Important - EINHELL LS 1800 Mode D'emploi

Important!

Empty the debris bag and the pre-screen before
blowing. Otherwise, material that has been
vacuumed up could drop out.
7.3.3 Emptying the debris bag and pre-screen
(Figs. 1, 3 - 5)
Empty the debris bag (6) in good time. When the bag
is heavily loaded with material, vacuum power is
considerably reduced. Deposit organic refuse at a
compost site.
Switch off the tool and pull out the plug.
b
Open the zipper on the debris bag (6) and
b
shake out the material.
For more coarse material, the pre-screen (8)
b
must also be emptied frequently. To do this,
remove the debris bag (5) in reverse order to
the instructions listed under assembly points 5.2
and 5.3, then empty the pre-screen (8).

8.0 Maintenance and cleaning

IMPORTANT!
All maintenance, service and cleaning work must
be performed after the power cord has been
pulled out.
Do not use high-pressure cleaners or running
b
water to clean the tool.
Do not use any aggressive cleaning agents.
b
After shaking out the debris bag, turn it inside
b
out and thoroughly clean it in order to prevent
mould and unpleasant odors from forming.
You can use soap and water to clean out a
b
heavily soiled debris bag.
Rub a bar of dry soap across the zipper teeth if
b
the zipper becomes difficult to pull.
Always keep the tool and ventilation slats clean.
b
Use a damp rag to wipe dirt marks off of the
b
tool. Clean the vacuum/blower tube with a brush
upon evidence of dirt and grime.
Dirt and grime can make the switch
b
(blower/vacuum) more difficult to operate as a
result of the material that swirls up off the
ground. When this occurs, simply flip the switch
back and forth a few times, which should bring it
back to the normal feel.
9.0 Repair
Should the tool experience problems beyond those
mentioned above, let only an authorized professional
or a customer service shop perform an inspection.
10.0 Disposal
The tool, accessories and packaging should be
disposed of in an environmentally-friendly fashion.
Plastic parts are coded for purposes of separation
when recycling.
GB
11