Télécharger Imprimer la page

Polaris FREEDOM Plus EB37 Serie Manuel D'installation Et D'utilisation page 9

Masquer les pouces Voir aussi pour FREEDOM Plus EB37 Serie:

Publicité

Les langues disponibles

Les langues disponibles

Polaris
Cordless Robotic Cleaner FREEDOM
®
3.5
Remote Control Status
Remote
Blinking
red blinking LED
NOTE: To replace batteries, use Phillips head screwdriver to remove
6 screws and replace batteries. Securely tighten screws after
replacement to ensure remote is watertight.
3.6
Start Cleaner
1. Select Cleaning Mode using the slider by sliding and
releasing to the left or by using the App.
Cleaning Mode
Select
Floor/Wall
Product or App
Floor
Product or App
SMART
In App
Waterline
In App
Figure 6. Slide and Release Left to Select Mode
NOTE: Choose Floor Only mode to clean with Pool Cover on.
2. Start the cleaner using the slider by sliding and
releasing to the right or use the App.
Figure 7. Slide and Release Right to Start
PLUS | Owner's Manual
Possible Cause
Solutions
Remote Battery
Remove
Power is Low
battery
cover and
replace
both AA
batteries.
Runtime
2.5 hrs
1.5 hrs
Calculated
0:45 min
3. Cleaning cycle will start as soon as the cleaner detects
the pool floor.
3.7
Submerge the Cleaner
1. At the center point, submerge the cleaner in the pool
and hold in the vertical position to release any air
trapped inside.
1
Figure 8. Submerge the Cleaner Vertically
2. For manual retrieval when cleaner is on the floor, attach
the hook (stored on the charging station) to a standard
pool cleaning pole (not included).
2
Figure 9. Cleaner Sinking to the Bottom of the Pool
3. Cleaning cycle will start as soon as the cleaner detects
the pool floor.
WARNING
Do not enter pool while the robotic cleaner is in water.
3.8
Remote Control
The LiFi remote control uses light signals to communicate
underwater with the cleaner. Use the remote to start/stop
a cleaning cycle, direct the cleaner, or remove the cleaner
from the pool. Bright sunlight may interfere with the signal.
Hold tip of remote underwater pointing at the cleaner's
antenna to send a command. Maximum distance between
remote control and cleaner is 20 feet (7m). The remote is
water resistant up to 1 foot (30cm) and floats if dropped
in water.
ENGLISH
Page 9

Publicité

loading