Citizen CD-S500 Série Mode D'emploi page 40

Chapter4 Maintenance Mode
Soft SW Setting Mode
Set item
Buffer Size
Init Signal
Buzzer
n
Interface-SW (Displayed only when the serial board is mounted)
Set item
Baud Rate
Data Length
Parity Bit
Stop Bit
Protocol
n
Mechanical-SW
Set item
Paper Width
Auto-Cutter
Color Ribbon
38
Initial value Setting value
4k 40byte
4Kbyte
ENB ENB
DIS
ON ON
OFF
Initial value Setting value
9600
19200
9600
4800
2400
1200
8 bit
8 bit
7 bit
NONE
NONE
EVEN
ODD
1 bit
1 bit
2 bit
DTR DTR
X-ON-OFF
Initial value Setting value
76.2 76.2
69.5
57.5
PAR. OFF
FREE
FULL
PAR.
ON ON
OFF
Remarks
The receiving buffer size is selected.
Selects enabled (ENB)/disabled (DIS) of the printer
initialized signal (PRIME) during centro-interface.
Selects enabled (ENB)/disabled (DIS) of the 25pin reset
signal during serial interface.
Selects buzzer sound when an abnormality occurs as
enabled (ON)/disabled (OFF).
Remarks
Sets the baud rate of the serial interface.
Sets the character length of the serial interface.
Sets the communication parity of the serial interface.
Sets the stop bit of the serial interface.
Remarks
Selects the paper size.
Selects the cutter operation.
When it is OFF, the FULL/PAR. commands do not start
cutting.
In FREE status, cutting is done according to the
FULL/PAR. commands.
In FULL status, full cut is always done by both the
FULL/PAR. commands.
In PAR status, partial cutting is always done by both the
FULL/PAR. commands.
Selects the color function.
During OFF, the change color command is ignored.