8.7.1 PAIRING THE DEVICE WITH THE FM20 WIFI FENCE MANAGER USING A REMOTE
CONNECTION
When pairing the device via a remote connection, the energiser and Fence Manager need not be
in close proximity with one another. This means that the pairing can also be carried out at the
location where the device will later be used.
I nfo
This function is only possible with the FM20 WiFi Fence Manager.
I nfo
»
The code displayed for pairing the device is valid for a maximum of 4 hours.
MAC Address
»
After 3 minutes, the display returns to the previous view and the LED goes out.
»
MAC Address
The code can also be accessed via the QR code displayed.
4. To pair the device with the Fence Manager, enter the code displayed in the FM20 WiFi Fence
Manager using the remote connection function.
8.7.2 PAIRING THE DEVICE WITH THE FENCE MANAGER VIA A DIRECT CONNECTION
When pairing the device via a direct connection, the energiser and Fence Manager must be in
close proximity of one another.
1. Position the energiser near the Fence Manager.
2. Carry out the pairing procedure in the Fence Manager as described in the instruction manual
for this device.
3. Switch the energiser to Pairing mode.
• To do this, press the on/off button briefly to switch the energiser to standby mode.
• Then hold the on/off button pressed for more than five seconds until the LED on the energiser
starts flashing.
The device can be paired with the Fence Manager.
56
1. Open the main menu and select the pairing
2. Confirm the selection with the Enter button (6)
3. To access the information on pairing for the
The information on pairing is displayed and the
blue LED flashes.
The device can be paired with the Fence Manager.
R E S E T
R E S E T
INSTRUCTION MANUAL VOSS.FARMING XTREME DUO RF
menu (Pairing) using the Settings button (7).
Fence Manager, select the menu item Pair new
using the Settings button (7), and confirm your
selection with the Enter button (6).
41550 - 11.2024 - V04