VOSS.farming XTREME duo RF Mode D'emploi page 46

I nfo
The power consumption is dependent on the device. If the device is to be powered solely by
a rechargeable battery, observe the technical specifications of the device in question and
check the voltage of the rechargeable battery regularly. The device is not well suited for
long-term operation using the battery alone, on account of the high energy consumption
and the low capacity of conventional batteries.
1. Connect the ground connector (13) to the grounding post
using the ground connection cable supplied. Follow the
tips in section 7.4 to ensure proper grounding.
2. Insert the mains adaptor connection cable (1) and/or
battery connection cable (2) into the connection(s) on the
device and screw the plug(s) tight (Fig. 1).
WA R NI N G
It is possible that explosive gas may form.
When using 12 V batteries (lead‑acid, AGM,
gel batteries), these must be placed in a well
ventilated location.
WA R NIN G AGA IN ST ELE CTRICAL VOLTAGES
»
Only insert the plug into properly installed sockets, otherwise it may result
in a short circuit or electric shock. The socket used should be equipped with
a residual current circuit breaker (RCCB) (≤30mA).
»
Only use the mains adapter supplied. The supply voltage must not exceed
15 V. The mains adaptor must only be connected once installation has been
completed in accordance with the regulations.
»
Check the mains adapter for possible damage before each use. If damaged,
do not use the mains adapter. Contact Customer Service for repairs.
N OTICE
»
Connect the energiser directly to the battery. Do not connect a solar charge
controller with a separate load output in between. These may damage the
energiser due to voltage fluctuations.
»
Avoid any contact between the 12 V plus and minus pole connecting terminals of the
battery connection cable. Otherwise the device may be damaged by a short-circuit.
I nfo
When connecting a battery, make sure that you use the 12 V screw connector port (4). If
the battery is connected incorrectly and its charging status is low, the energiser does not
give any signal (see Section 6.3) and the device switches itself off.
3. Connect the fence connector (11 and/or 12) to the fence using the fence connection cable.
I nformation on u se of the yell ow fe nce co nne c t io n
The yellow fence connection (12)
has two applications:
∙
for a fence for younger or more
sensitive animals
∙
in combination with the red
fence connection (11) on a fence
with separate conductors. To do
this, connect the yellow fence
connection (12) to the lower
conductor of the fence and the
red fence connection (11) to the
upper conductor of the fence:
46
INSTRUCTION MANUAL VOSS.FARMING XTREME DUO RF
1
2
4
3
Fig. 1
41550 - 11.2024 - V04