EVOC COMMUTE A.I.R. PRO Manuel D'instructions page 19

MAINTENANCE
Care | Cleaning
To clean your COMMUTE A.I.R. PRO, first remove the MINERVA AIRBAG SYSTEM from the
backpack.
Removing and refitting the MINERVA AIRBAG SYSTEM
Initially, ensure that the system is deactivated by placing the chest strap in the park position (Fig.
2.3). Now remove the inflator and fit it with the appropriate protective cap (Fig. 5.3 a-c).
• Always ensure that you FIRST remove the inflator before removing the system!
Now open the airbag compartment to above both shoulder straps by undoing the central hook
and loop fastener and unzipping the zip over its white central burst section. When the airbag is
exposed, undo the eight fasteners between the airbag and the backpack. The airbag is attached
to the backpack with four such fasteners on each side. Both the tabs and fasteners are
numbered for safer and easier reassembly of the system (Fig. 8).
Fig. 8
Now reach into the airbag compartment and disconnect the plug connector between the
triggering unit and triggering buckle cables (Fig. 9). Also remove the triggering buckle from the
shoulder straps. The triggering unit and airbag can now be removed upwards from the airbag
compartment.
Although the system is splash-proof, please avoid direct contact between the triggering unit
and water or liquids. If the airbag is dirty, it can be cleaned using a damp cloth.
Wash the backpack and back protector by hand (max. 30°C) using gentle detergents (neutral
soap). Allow the backpack to air dry – do not machine dry or use other heat sources.
Be aware that machine washing will void the warranty.
EN
19