EVOC COMMUTE A.I.R. PRO Manuel D'instructions page 11

Fig. 5.3a
Remove the black protective cap from the inflator
(Fig. 5.3a) and ensure that the locking pin is fully
extended before inserting it into the triggering unit
(Fig. 5.3b). It should be possible to insert the inflator
without much resistance; the correct position is
confirmed when you hear it click into place. Secure
the inflator by pushing the locking pin completely into
position (Fig. 5.3c).
The entire system unit can now be stowed back into
the airbag compartment (Fig. 5.4).
Ensure that the unit is stowed in the black neoprene
sleeve provided inside the compartment (Fig. 5.4a);
this will hold the system unit in position in the event
of deployment.
Now close the airbag compartment zip.
Your COMMUTE A.I.R. PRO is now ready for operation
(Fig. 5.5).
Fig. 5.3b Fig. 5.3c
Fig. 5.4
Fig. 5.5
EN
a
11