EVOC COMMUTE A.I.R. PRO Manuel D'instructions page 16

EN
RE-USING THE MINERVA AIRBAG SYSTEM
The following descriptions can also be found in the form of video instructions by scanning the
QR code above.
Folding the airbag
Open the airbag compartment within the main compartment (Fig. 5.1), pull out the triggering unit
along with the inflator, remove the inflator and fit it with the corresponding protective cap (Fig. 5.3 a-c).
Compressing the airbag causes the residual air to escape. Repeat this process until the air has
been fully evacuated from the airbag.
Place the backpack on a flat surface with the back section and shoulder straps facing upwards.
Now fully open the zip on the shoulder straps once, before zipping the slider back from the left
to the right shoulder strap (Fig. 7.1). Re-insert it there and close the zip by 2 – 3 cm.
Spread the airbag out to its full size (Fig. 7.2).
Fig. 7.1
RIGHT
SIDE
16
If the triggering parameters are reached in a fall or a fall-like situation, the
MINERVA AIRBAG SYSTEM is automatically deployed and the LED on the
chest strap triggering buckle illuminates continuously red. Following a visual
inspection and after fitting a new, original inflator, as well as folding the
airbag appropriately, the system can be returned to full functionality again.
LEFT
SIDE
Fig. 7.2