EVOC COMMUTE A.I.R. PRO Manuel D'instructions page 13

Opening the triggering buckle deactivates the system and this status is indicated by the LED
flashing red three times and then extinguishing. The top of the triggering buckle must now
be moved to the park position on the right shoulder strap.
LED colour
Flashing green
Flashing red/green
Flashing red
Continuous red light
Troubleshooting
Fault description
LED flashes
red/green
LED lights
continuously red
The system does not
react
The inflator cannot be
connected
Meaning
System is in use and will operate for at least another 4 hours
System is in use and will operate for less than 4 hours
If possible, stop using the system and charge it immediately,
otherwise an undesired system failure may occur.
The system is charging; the LED will stop flashing as soon
as the battery is fully charged.
The system is not ready for use. First follow the trouble-
shooting procedure or contact our service team.
Fault diagnosis
Red/green flashing is a warning signal and means that
the battery life is limited to just 4h. Charge the system and
check the charge status. If the LED continues to flash
red/green after charging for 3h, check the plug connection
between the triggering unit and charging cable. Contact
our service team if the LED continues to flash red/green.
The system is not ready for operation if the LED indicates
red. In this case, check whether the inflator is still full
and/or use a new one if necessary. Make sure that the
inflator is correctly connected. Contact our service team
if the LED continues to indicate red.
First, fully charge the system and re-install the inflator.
Contact our service team if the system still does not react.
The inflator must be inserted into the triggering unit over-
coming slight resistance. When connecting, ensure that the
inflator contacts are correctly inserted into the triggering
unit and that the locking pin is fully extended (Fig. 5.3b).
Please contact our service team if you have any questions.
EN
13