TECHCON TS350 Mode D'emploi page 6

2. Press and release the reset button (3) until the colon (:) in the
"TIME:" is flashing
3. Rotate the Setup control knob (8) to set the desired dispense time
4. Depress Foot switch to activate timed dispensed cycle
6.3 Teach Mode Setting
In the teach mode, the unit will accumulate time as long as the foot switch is
depressed. This is helpful in determining dispense time required when
dispense output is unknown.
Press the Mode button (2) to select "TEACH" mode
1.
2. Press and release the reset button (3) until the dispense time = 0.000S
3. Press and hold down Foot switch. Dispense time will accumulate
during this time
4. Release Foot switch when proper amount of fluid is dispensed
Press the Mode button (2) to switch the "TIMED" mode
5.
6. The dispenser is now set to repeat this time cycle.
6.4 Multiple Shots Setting:
Up to ten separate individual or sequenced shots can be stored in the
TS350/TS355.
Follow steps in section "6.2 Automatic Dispense Cycle Setting" to set
1.
dispense time in desired programs
2. Press both the Reset button (3) and the Power button (1)
simultaneously to activate sequence program mode
3. Rotate the Setup Control knob to select total number of program to be
dispensed in sequence
4. Press both the Reset button (3) and Power button (1) to exit Multiple
Shots mode
6.5 Cycle Counter
The cycle counter records the numbers of automatic dispense cycle being
activated. Up to 65,535 cycles can be recorded. This number is shown at
the lower right hand corner of the LCD. To reset the counter, press and hold
the Reset button (3) and the Mode button (2) simultaneously until the
counter shows "0".
6.6 Change Pressure and Vacuum Unit Display
1. Press and release the reset button (3) until the colon (:) in the
"PRESSURE:" or "VACUUM:" is flashing
2. Rotate the Setup control knob (8) to select desired unit display
6