Dorman 911-914 Instructions De Montage

911-914
INTAKE MANIFOLD
RUNNER CONTROL
BEFORE YOU BEGIN:
• Always wear proper safety
equipment when performing repairs.
• Ensure at your point of purchase
that this part fits your exact
vehicle configuration.
• Reference the appropriate service
manual for your vehicle. If you do
not have a service manual, and do
not have the training or experience
to perform the necessary
procedures correctly, seek the
services of a qualified technician.
NEED HELP?
Please call our Technical Support
team for assistance from our team of
certified automotive experts.
1-866-933-2911
© 2022 No reproduction in whole or in part without prior written approval.
911-914_Tech-Note
Please make sure two steel arms are installed correctly as shown in
diagrams. Arm 2 must be installed in hole near semicircular notch
(shown in second image below), and Arm 1 must be installed in hole away
from semicircular notch. Arm 1 should be aligned with blue mark and
Arm 2 should be aligned with yellow mark.
Additional arm bushings are included in the package. These can be used
to replace any existing bushings on the mating intake manifold, as they
are a common OE failure point. The same bushings can also be used to
mate the arm to the IMRC actuator, should the preinstalled ones ever
need to be replaced.
Blue mark
Arm 2
Yellow mark
Blue mark
Arm 1
Dorman Products, Inc. Corporate Office and Customer Service: 1-800-523-2492.
Disclaimer: Even though every attempt is made to ensure this information is complete and accurate, it is impossible to account for all possible
circumstances or situations. Please consult with a qualified auto technician before attempting to perform any work you are not qualified to
do. Automobiles can be hazardous to work on; be sure to take all necessary safety precautions. Failure to do so may result in property damage
or personal injury. Certain motor vehicle standards and performance requirements may apply to your motor vehicle (such as Federal Motor
Vehicle Safety Standards by the National Highway Traffic Safety Administration). Be sure that your work is performed in accordance with such
standards and that you do not disable any motor vehicle safety feature.
Arm bushing
PAGE 1 OF 3
Arm 1
Yellow mark
Semicircular notch
Arm 2