Dorman 917-504 Manuel D'instructions

INSTRUCTIONS
EXHAUST
MANIFOLD CLAMP
REPAIR
917-504
Clamping bolt
BEFORE YOU BEGIN:
• Always wear proper safety
equipment when performing repairs.
• Ensure at your point of purchase
that this part fits your exact
vehicle configuration.
• Reference the appropriate service
manual for your vehicle. If you do
not have a service manual, and do
not have the training or experience
to perform the necessary
procedures correctly, seek the
services of a qualified technician.
NEED HELP?
Please call our Technical Support
team for assistance from our team of
certified automotive experts.
1-866-933-2911
© 2023 No reproduction in whole or in part without prior written approval.
917-504_Instructions
NOTE: Allow engine to cool before beginning work.
INSTRUCTIONS
STEP 1:
Verify that remaining portion of broken manifold bolt is not protruding past exhaust manifold surface.
Grind flush if necessary.
STEP 2:
Apply high temperature thread locking compound to threads on two included mounting bolts
before installation.
STEP 3:
Attach clamp to cylinder head by using
unused factory holes as shown.
STEP 4:
Mounting bolts
Tighten clamp mounting bolts through the two unthreaded holes on clamp to a torque of 30-35 lbs-ft
(40-47 N-m).
STEP 5:
Apply high temperature thread locking compound to threads on clamping bolt, install through threaded
hole in clamp. Tighten only until the exhaust seals up. The clamping bolt should contact the manifold
flange, offset from the bolt mounting hole. Tighten to 35 lbs-ft (47 N-m).
STEP 6:
Check for any exhaust leaks. If leaks are present, continue tightening until the leaks disappear without
exceeding 40 lbs-ft (54 N-m).
Dorman Products, Inc. Corporate Office and Customer Service: 1-800-523-2492.
Disclaimer: Even though every attempt is made to ensure this information is complete and accurate, it is impossible to account for all possible
circumstances or situations. Please consult with a qualified auto technician before attempting to perform any work you are not qualified to
do. Automobiles can be hazardous to work on; be sure to take all necessary safety precautions. Failure to do so may result in property damage
or personal injury. Certain motor vehicle standards and performance requirements may apply to your motor vehicle (such as Federal Motor
Vehicle Safety Standards by the National Highway Traffic Safety Administration). Be sure that your work is performed in accordance with such
standards and that you do not disable any motor vehicle safety feature.
Mounting bolt
Existing threaded holes
Exhaust manifold clamp
Mounting bolt
Clamping bolt
PAGE 1 OF 3