Use; Gas Leaks - Qlima BGHX 145 Manuel D'utilisation

USE

The knobs for turning the gas heater ON are located on the upper part of the heater:
• Open the gas container (follow the user instructions provided with the low-pressure
regulator).
Figure 3
1. ODS
2. Safe guard
3. Cover
4. Control knob
5. Ignitor
USING THE HEATER:
Figura 3.1
1. Open the gas cylinder and/or regulator valve.
2. Press down the control knob of the heater and hold down for minimum 30 seconds.
While holding down the control knob, press the igniter button several times until
the ODS is light (this can take up to 15-20 seconds (*)). Release the control knob
about 1-20 seconds after the ignition flame is visible. After the flame is visible, the
burner is on, now turn the control knob to "
(*) NOTE: If this the first time use for heater or gas cylinder has been replaced, it may
take a couple of seconds for the fuel to reach the heater. Continue to hold the
flame until the ceramic plaques ignite. If they do not ignite after 15 seconds,
extinguish the flame, close the gas cylinder, wait 5 minutes for any propane to
dissipate and repeat steps 1-2.
• To turn OFF the device, close the gas container (follow the instructions provided
with the low-pressure regulator).
• Do not hold the regulation knob pressed down for longer than 40 seconds.
• Never move the heater when it is hot and/or in operation.
After use the appliance is still very hot. Make sure to have it cooled down
•
completely.

GAS LEAKS

If you think there may be a gas leak, please follow this procedure:
• Close the gas container (follow the user instructions for the regulator);
"position for maximum power.
4
35