Tips For Recording From Mds To Tape - Sony MDS-PC2 Mode D'emploi

Tips for Recording From
MDs to Tape
Z
MENU/NO
H
z
./>
.
m
Note
When recording from an MD to another component connected to
the analog output jacks on the deck, be sure to adjust the output
level to 0 dB by pressing ANALOG OUT LEVEL + until "ATT"
turns off in the display.
Inserting blanks between tracks during
play (Auto Space)
The MD deck can be set to automatically insert a three-
second blank between tracks during play. This function is
useful when you're recording from an MD to an analog
tape since the three-second blank enables you to use the
Multi-AMS function later to locate the beginning of tracks
on the tape.
1
While the deck is stopped, press MENU/NO twice.
"Setup Menu" appears in the display.
2
Press ./> repeatedly until "Auto" appears,
then press YES.
3
Press ./> repeatedly to select the setting,
then press YES.
To
Turn on Auto Space
Turn off Auto Space
4
Press MENU/NO.
Notes
• If you select "Auto Space" and record a selection containing
multiple track numbers (for example, a medley or symphony),
blank spaces will be created on the tape in between the various
sections.
• If you turn off the deck or disconnect the AC power cord, the
deck will store the last setting ("Auto Space" or "Auto Off")
and recall it the next time you turn on the deck.
28 GB
` / 1
YES
– +
X
x
>
+
M
–
Select
Auto Space
Auto Off (factory setting)
Pausing after each track (Auto Pause)
You can set the MD deck so that it pauses after each track
to give you time to locate the next track to be recorded.
1
While the deck is stopped, press MENU/NO twice.
"Setup Menu" appears in the display.
2
Press ./> repeatedly until "Auto" appears,
then press YES.
3
Press ./> repeatedly to select the setting,
then press YES.
To
Turn on Auto Pause
Turn off Auto Pause
4
Press MENU/NO.
To resume play after pausing
Press H (or NX on the deck).
Note
If you turn off the deck or disconnect the AC power cord, the
deck will store the last setting ("Auto Pause" or "Auto Off") and
recall it the next time you turn on the deck.
Select
Auto Pause
Auto Off (factory setting)