Using The Display - Sony MDS-PC2 Mode D'emploi

Using the Display

The display window shows information about the MD or
track. This section describes the information that appears
for each deck status.
Z
DISPLAY
H
z
.
m
Note
The type of information (e.g., total number of tracks, recorded
time, remaining time, track or disc name) which was last
displayed will continue to appear until you change it by pressing
DISPLAY, even if you change the deck operation status. For
example, if the remaining time was displayed when you stop the
deck, the remaining time will continue to appear when you begin
playing the same MD again or a different one.
When you insert an MD
The display automatically changes as follows:
Disc name
S O N G S
Total number of tracks Total recorded time
1 5
` / 1
SCROLL
+
–
X
x
>
+
M
–
4 6 m 0 8 s
While the deck is stopped
Press DISPLAY repeatedly to change the display.
Each press of the button changes the display as follows:
Total number of tracks and total
recorded time (default display)
1 5
Remaining recordable time on the
MD (recordable MDs only)
**
Disc name
S O N G S
Not shown for the premastered discs.
*
When the MD has no name, "No Name" appears, followed by the
**
default display.
While the deck is recording
Press DISPLAY repeatedly to change the display.
Each press of the button changes the display as follows:
Track number and recorded time of
the current track (default display)
1 6
Remaining recordable time on the
MD
Level of the input signal
*
Track name
B A L L A D
When the track has no name, "No Name" appears, followed by the
*
default display.
4 6 m 0 8 s
Press
*
- 2 7 m 5 2 s
Press
Press
3 m 0 5 s
Press
- 2 4 m 4 7 s
Press
Press
Press
11 GB