Broncolor RFS 2.1 Mode D'emploi page 9

Transceiver technical data
Studio address setting range
Lamp address setting range
Radio frequency channels (automatically regulated)
Frequency
Transmission time (transmitter to receiver)
Central shutter speed
Focal-plane shutter speed
Flash triggering possible via:
> Integrated hot shoe on central contact
> Lateral 3.5 mm sync jack in or out
Range outdoors
Range indoors
Range
Integrated antenna
Dimensions (L x W x H)
Weight
16
1 – 99
1 – 40
40
2.4 GHz
0.425 ms
up to 1/1500 s
up to 1/320 s
up to 50 m
up to 30 m
up to 200 m
68 x 38.5 x 33 mm /
2.7 x 1.5 x 1 inch
46 g / 35 oz
(including battery)
Releases per second
Button cell battery in transceiver
Automatic switchover to energy-saving mode after
Typical battery life
Sync voltage
In the event of problems and undefined communication malfunctions bet-
ween RFS 2.1 devices, the cause may be strong frequency interference.
In such cases, make sure the devices are not within the range of baby
phones, video bridges, microwave ovens, cordless dect telephones, Wlan
routers or Bluetooth devices, or use a different studio channel.
Subject to change in the interest of technical progress.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
100
Li-Mn CR2450
(560 mAh, 3 V)
8 hours
approx. 8 – 12 months
or 100,000 flashes
3 V
17