Broncolor RFS 2.1 Mode D'emploi page 5

2.2 RFS 2.1 transceiver as receiver
The device can be used as an external receiver for broncolor power packs,
monolights, and third-party units that are not equipped to receive RFS 2 or
RFS 2.1 data. When using the device as a receiver, use the respective power
supply unit and plug it into the USB socket on the side of the device. The
device will automatically switch to the receiver mode.
Connect the sync cable with the "out" jack of the RFS 2.1 transceiver and the
sync jack on the flash unit.
2.3 Operation
> Keys
The device has four keys: "test", "set", "
mode of the device, they have different functions. The functions depend on
how long the keys are pressed.
> Key press duration
A short key press is shorter than a second, a longer actuation is longer than
a second.
8
" and " ". Depending on the current
 
3. SET THE STUDIO ADDRESS
The transceiver must have the same studio address as the flash units or
receivers that are to be used.
To set the studio address, please proceed as follows
(the RFS 2.1 transceiver must be in "ST" mode. Should "LP" mode be selected,
change to mode "ST" by pressing "set" for more than a second):
1. Press the "set" key briefly until the display blinks "ST" and shows the
studio number.
2. Set the studio address with keys "
3. Save the setting by pressing the "set" key briefly. The transceiver
synchronises with the flash units and "ST" is shown in the display
(not blinking).
" and " ".
 
9