Broncolor RFS 2.1 Mode D'emploi page 8

Mode "LP"
Briefly press the key " ":

The lamp channel indicated increases its total output by 1/10 f-stop
Briefly press the key " ":

The lamp channel indicated reduces its total output by 1/10 f-stop
P ress the key "
" for more than a second:

The lamp channel indicated increases its total output by 1 f-stop
P ress the key "
" for more than a second:

The lamp channel indicated reduces its total output by 1 f-stop
> Resetting the device
To reset the device to factory settings, first press and hold the "test" key and
then press the "set" key for more than four seconds. This resets the device.
14
6. COMPATIBILITY
System Compatible with
RFS 2.1 RFS 2.1
RFS 2
RFS 2 RFS 2
RFS 2.1
RFS RFS
Comments
On units with RFS 2, individual lamp and
modelling light settings are not possible
Only RFS 2 functions are available,
individual lamp and modelling light
settings are not possible
No compatibility with RFS 2 or RFS 2.1.
Also no flash triggering
15