Energy Control - Broncolor RFS 2.1 Mode D'emploi

4. SET THE LAMP CHANNEL
With the RFS 2.1 transceiver you can define and adjust the individual lamp
outlets on the flash units as you wish. To make the adjustments, please fol-
low the procedure given in the operating instructions for the flash unit con-
cerned.
To set the lamp address, proceed as follows
(the RFS 2.1 transceiver must be in "LP" mode. Should the "ST" mode be
selected, please change to mode "LP" by pressing "set" for more than a se-
cond):
1. Press the "set" key briefly until the display blinks "LP" and shows the
lamp number.
2. Use the " " and " " keys to set the lamp address.
 
3. Save the setting by pressing the "set" key briefly. "LP" will now be
displayed (without blinking).
12

5. ENERGY CONTROL

The RFS 2.1 transceiver allows you to change the power outlet of all RFS 2
or RFS 2.1 flash units that are set to the same studio address (in "ST" mode),
and to change the output of individual lamp channels (in "LP" mode). The
output can be adjusted in 1/10 and full f-stops.
Mode "ST"
Briefly press the key " ":

all the RFS 2 or RFS 2.1 units increase the total energy by 1/10 f-stop
Briefly press the key " ":

all the RFS 2 or RFS 2.1 units reduce the total energy by 1/10 f-stop
P ress the key "
" for more than a second:

all the RFS 2 or RFS 2.1 units increase the total energy by 1 f-stop
P ress the key "
" for more than a second:

all the RFS 2 or RFS 2.1 units reduce the total energy by 1 f-stop
13