Broncolor RFS 2.1 Mode D'emploi page 3

BRONCOLOR RADIO FREQUENCY SYSTEM 2.1
Before use
We are very pleased you have chosen a broncolor Radio Frequency System
RFS 2.1 unit, which is a high-quality product in every respect. If used properly,
it will render you many years of good service. Please read the information
contained in these operating instructions carefully. They contain important
details on the use, safety and maintenance of the device. Keep these opera-
ting instructions in a safe place and pass them on to further users if neces-
sary. They are also available online at www.broncolor.com.
With the broncolor RFS 2.1 you can trigger and operate by remote control
broncolor units, which are equipped with an integrated RFS 2 or RFS 2.1 in-
terface.
4
1. OPERATION AS TRANSMITTER OR RECEIVER
The transceiver can be operated in two modes. The unit is always in trans-
mitting mode when used in battery operation. The transceiver functions as
transmitter.
If the transceiver is supplied with energy through the provided power supply
unit via the USB port, the device switches over automatically to receiving
mode. The transceiver functions as receiver.
It is not necessary to switch modes manually.
1.1 Locking and unlocking the unit
(The unit will be switched off completely, this excludes the possibility of
unintentional operation.)
To lock the unit, please proceed as follows:
1. Press the „test" and „set" buttons simultaneously. Hold for two seconds
and „SL" appears bright in the display.
2. Release the two buttons after two seconds. The lock is now activated.
To unlock the unit, please proceed as follows:
1. Press the „test" and „set" buttons simultaneously. After two seconds „SL"
in the display goes dark.
2. Release the two buttons after two seconds. The display shows the last
active status. The unit is unlocked.
5