Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
englIsh
how to make adjustments
Loosen the clamping screw
. Dock the adjustment key as described.
3
Wait until the light ring
of the adjustment key indicates that it is ready to
4
operate by flashing.
Briefly press the ON button of the display unit in order to confirm data reception.
The connection between the display unit and the adjustment key is established.
Wait until light ring
of the adjustment key indicates that it is ready to operate
4
by remaining lit.
For D mode only: If the display is in difference mode
, the R button can now
5
be pressed and held until „0.0000" is displayed on the screen.
Adjust the required measurement by turning the handwheel. N.B.: Check your
adjustment mode.
Tighten the clamping screw
to 8 Nm. We recommend the use of a torque
3
wrench. Remove the adjustment key as described.
3
5
6
4
27
Publicité
Chapitres
Table des Matières
