Output Supplied; Burner Equipment - Riello Rx 360 S/Pv Instructions Pour Installation, Utilisation Et Entretien

4.5

Output supplied

The diagrams (Fig. 3) allow you to set the power output either us-
ing the number of fan revs or using the pressure downstream of
the gas valve (P2) Fig. 19 on page 22.
Example:
Natural gas GG20 operation NCV 9.45 kWh/Sm
pressure on point 1 = - 12 mbar (See dotted line).
The burnt output corresponds to 300 kW.
Going vertically up the diagram, to intersect the not dotted line,
you can estimate the value of the number of revs on the left hand
y-axis: in this case 4800 rpm.
Pressure
No. revs
Pressure
No. revs
4.6

Burner equipment

Flange for gas train . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . No. 1
Air intake . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . No. 1
Gas pipe . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . No. 1
Screws M 5 x 16 for securing the valve . . . . . . . . . . . . . . No. 4
Insulating screen and gasket . . . . . . . . . . . . . . . . . . . . . . No. 1
Gas valve . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . No. 1
4-pin plug . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . No. 1
7-pin plug . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . No. 1
Small parts unit. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . No. 1
Instructions. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . No. 1
Spare parts list . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . No. 1
20068189
Technical description of the burner
3
Thermal power – kW
Thermal power – kW
10 GB
For an exact reading of the number of revs there
is a kit for interfacing with the control box.
WARNING
Hardware for burner assembly:
8 x 50 zinc-plated nuts (with or without tip) . . . . . . . . . . . . No. 4
Zinc-plated washers Ø 8 . . . . . . . . . . . . . . . . . . . . . . . . . . No. 4
Zinc-plated toothed washers Ø 8 . . . . . . . . . . . . . . . . . . . . No. 4
M8 Zinc-plated nuts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . No. 4
The burner is supplied with combustion head and
electrodes assembled.
WARNING
Fig. 3