Right-Hand Panel Controls; Controls On The Manuals - Viscount Prestige VIII - IX Mode D'emploi

1.3 RIGHT-HAND PANEL CONTROLS

2
1
&5(6&(1'2 0$1 ,, 75$16326(5

1.4 CONTROLS ON THE MANUALS

1
1. Set button (S): This button is used to activate the memory save function. See chapter 2 for further information.
2. Memories (HR; 1 - 2 - 3 - 4 - 5 - 6): All selection made with the tab registers including the sections MIDI and Couplers
can be memorized. See chapter 2 for memory programming. Memories include a push-button marked HR (it can be also
called 0). This memory memorize temporarely the last configuration present at time when the piston was switched on.
3. Enclosed (ENC): After this button has been pressed, the second manual expression pedal can be used to control the
general volume of the entire organ.
4. Automatic Pedal button (A.P.): By pushing the A.P. piston, you will play the pedalboard registers on the first 32 keys
of Man I. These registers will become monophonic with priority on the lowest note. When utilizing this function, the
pedalboard will not play.
5. Tutti (T): The Tutti enables a series of preset registers. You can recall this function – in case of the model Prestige IX –
also through the toe piston located right of the expression pedal.
N.B.: The Tutti does not activate the modulation voices, the tremolos and the Vox Celeste. The phonic composition of the
TUTTI can be programmed (see chapter 2).
6. Cancel button (C): By pushing this piston the HR piston will be on and the activated registers will be off.
Function Set + Cancel: when the MIDI is connected to another VISCOUNT organ, the activation of a register on the
transmitting organ will (through the sending of an exlusive system message) activate the same register on the receiving
organ. If you wish that some registers will not play on the transmitting organ but, when selected, will play only on the
receiving organ, you have to follow this procedure:
- Press Set (S) piston and at the same time Cancel (C): all tabs will be on.
- Switch off the tabs you do not wish to sound on the receiving organ.
- Press again Set + Cancel.
Viscount PRESTIGE VIII - IX
1. Transposer/Bank Section: This section contains the display for the Transposer,
which is between -6 and +5 semitones: turn the knob under the display in either
direction to modify the transposition value. At the bottom on the right there are 8
%$1.
memory banks with the relative display to show the selection made; here again, turn
the knob under the display to select the required value.
2. LED meter: these led meter will display the CRESCENDO step and the level
of the second manual. In the organ mod. Prestige VIII the left meter will display
the level of the pedal and of the first manual.
3. Floppy-Disk Driver: This drive is able to take 3.5 inch floppy disks with
capacity 720 kBytes (2DD) or 1.44 Mbytes (2HD). All information about the organ
3
parameter settings can be saved to these disks, and they can also be used to record
your performances (see chapters 4 and 6).
2
3
32
4 5 6