Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
General
With a mulching kit, a conventional lawn
mower can be converted into a mulching
mower. For this purpose, the mowing
blade must be replaced with the mulching
blade and the grass catcher box must be
replaced with the mulch insert.
To enable the machine to be used again
as a grass collector, the mulching blade
must be replaced again with the mowing
blade.
0.1 General
This instruction manual constitutes
original manufacturer's instructions in
the sense of EC Directive 2006/42/EC.
VIKING is continually striving to further
develop its range of products; we therefore
reserve the right to make alterations to the
form, technical specifications and
equipment level of our standard
equipment.
For this reason, the information and
illustrations in this manual are subject to
alterations.
This instruction manual is protected by
copyright. All rights reserved, especially
the right of reproduction, translation and
processing using electronic systems.
1. For your safety
Observe the instruction manual of the lawn
mower, particularly the "For your safety"
and "Maintenance" sections. The
instructions for blade maintenance must
always be observed.
0478 909 9919 A - EN
Detach the spark plug socket before
performing any work on the lawn mower.
Additionally close the tank ventilation
screw before placing the machine in the
cleaning position.
Before each use, perform a visual check to
ensure that the mulch insert, mulching
blade and blade fastening are in good
condition.
Only use the mulch insert in conjunction
with the mulching blade.
Printed on chlorine-free bleached paper. Paper is recyclable. Cover is halogen free.
2. Standard equipment
Item
Designation
A
Mulch insert
B
Mulching blade
C
Screw
D
Spring washer
–
Instruction manual
3. Assembly
3.1 Removing the mowing blade
● Locate the handlebar in the
service position.
● Remove the mowing blade.
See the instruction manual for the lawn
mower for a description of how to do this.
3.2 Installing the mulching blade
● Clean the blade contact surface
and blade holder.
● Secure blade fastening screw (C) with
Loctite 243.
● Fit mulching blade (B) on the blade
holder with the tabs (1) facing
outwards.
● Position spring washer (D) with the
convex facing outwards and tighten
with blade fastening screw (C) to
60 - 65 Nm.
1
Qty.
1
1
1
1
1
2
3
4
5
Publicité
Table des Matières
