GE GeoSpring GEH50DEEDSRA Manuel D'utilisation Et D'installation page 21

Fault codes. GEApp,i°nces.com
Fault Code
Displayed Condition Action
F-A T4 Not Rising Call service
F-B Discharge Ternp Not Stable Call service
F-C Evaporator Not Frost Free Call service
F-D Superheat Too Low Call service
F-E Discharge Temperature Above Limit Call service
F-F Electronic Expansion Valve Out of Range Call service
F2 T2 Tank Temperature Sensor Failure Call service
F-3 Compressor Failure Call service
F-4 Fan Failure Call service
F-5 T3a Sensor (Evap inlet temperature) Failure Call service
F-6 T3b Sensor (Evap outlet temperature) Failure Call service
F-7 T4 Sensor (Compressor outlet) Failure Call service
F-8 T5 Sensor (ambient temperature) Failure Call service
F-9 Lower Heating Element Failure Call service
F-IO Upper Heating Element Failure Call service
F-II
Dry Tank Fault See page 16
F13 Stuck Key Fault Call service
F15 DataFlash Fault Call service
bAd linE The voltage is too low at power-up See page 16
Note: If your unit shows "PS" on the display when trying to adjust the temperature, this is not a
fault code. "PS"indicates that the unit is operating with the ACM module and is in Power Saver
mode. See page 10 for details.
21