Yamaha 40V Manuel D'utilisation page 48

UP
UP
DN
DN
EMU01331
Power Trim/Tilt Switch
The power trim/tilt adjusts the motor
angle in relation to the transom. The
power trim/tilt switch is located on the
remote control lever grip. Pushing the
switch "UP" trims the motor up, then tilts
the motor up. Pressing the switch "DN"
tilts the motor down and trims the motor
701034
down.
released, the motor will stop in its current
position.
NOTE:
Refer to the sections "ADJUSTING TRIM
ANGLE" and "TILTING UP/DOWN" in
Chapter 3 for instructions on usage.
EMC87011*
Throttle friction adjusting screw
A friction device in the remote control box
provides resistance to movement of the
remote control lever.
This is adjustable for operator preference.
An adjusting screw is located at the front
of the remote control box.
Resistance
Increase
Decrease
w
Do not overtighten the friction adjusting
screw.
If there is too much resistance, it may be
difficult to move the lever, which could
result in an accident.
701035
2-11
When the switch
Screw
Turn clockwise
Turn counterclockwise
GB
button is