Checking Power Trim And Tilt System - Yamaha 40V Manuel D'utilisation

q
EML02111
CHECKING POWER TRIM AND TILT
SYSTEM
w
8 Never get under the lower unit while it
is tilted, even when the tilt-support
lever is locked. Severe injury could
occur if the outboard accidentally falls.
8 Make sure no one is under the out-
board before performing this test.
Procedure
w
1) Check the power trim and tilt unit for
any sign of oil leaks.
2) Operate each of the power trim and
tilt switches on remote control and
engine bottom cowling (If equipped)
to check that all switches work.
3) Tilt up the motor and check that the
trim and tilt rod is pushed out com-
pletely.
4) Use the tilt-support lever to lock the
motor in the UP position. Operate the
tilt down switch briefly so the motor
is supported the tilt-support lever.
5) Check that the trim and tilt rod is free
of corrosion or other flaws.
6) Activate the tilt-up switch until the
trim and tilt rod is fully extended
again. Unlock the tilt-support lever.
1 Trim and tilt rod
2 Tilt support lever
7) Operate the motor to trim and tilt
down. Check that the trim and tilt rod
operates smoothly.
4-21
GB