Storing Settings In The Memory; Getting Out The Preset Memory - Alpine DVA-9965 Mode D'emploi

Storing Settings in the Memory

Up to 6 settings can be stored on the unit.
All settings and adjustments described below are stored in one
memory preset.
Setting/adjusting items
Setting the Speakers
Setting Time Correction/Switching Phase
Adjusting EQ
Adjusting X-OVER
Setting MX
Setting BASS COMP.
Setting PRO LOGIC II/Adjusting the
Centre Width*
Adjusting Dolby Surround*
Linear PCM Setting*
* Depending on the input signal, sound effect may not be obtained.
1
Press MENU.
2
Touch the GlideTouch bar, select AP Preset Mode
by sliding it to the left or right, then press
GlideTouch bar.
3
Touch the GlideTouch bar, select the preset
number (1 through 6) by sliding it to the left or
right, then press and hold the GlideTouch bar for
at least 2 seconds to store the adjusted contents.
• This function is operable only when Defeat is set to OFF.
• The stored contents will not be deleted even when battery power
cord is detached.

Getting out the Preset Memory

1
Check that Defeat mode is off (page 20).
2
Press MENU.
3
Touch the GlideTouch bar, select AP Preset mode
by sliding it to the left or right, then press the
GlideTouch bar.
4
Touch the GlideTouch bar, and select a preset
number (1 through 6) you wish to recall by sliding
it to the left or right, then press the GlideTouch
bar.
• It takes a few moment to get out the preset memory.
Refer to page
46
47, 48
48, 49
46
46
49
52
50, 51
52
53
-EN