Uline Ohaus Explorer Mode D'emploi page 10

3. A new screen appears with the message: Place 30
pieces. Press ACCEPT.
NOTE: Default is 10 pieces, but message
matches number of pieces in SAMPLES button.
4. After following these instructions, press RETURN TO
APPLICATION on the main edit settings screen.
PARTS COUNTING – FILL
This feature permits establishing a set quantity of pieces
as a reference, so when pieces are added, their
percentage of the reference amount appears.
A Progress bar indicates the percentage.
1. In the upper left portion of the home screen, select
PARTS COUNTING. (The option will appear if it has
been enabled in the application modes menu.)
2. Press the SETUP button to enter the counting setup
menu.
3. Change counting mode to fill counting.
4. The default (or last) APW is displayed. Place objects
on the pan to display the fill status.
PAGE 10 OF 106
OPERATION CONTINUED
EDIT SETTINGS
Touch the EDIT SETTINGS button. The settings screen
appears.
The buttons for APW, SAMPLES and TARGET show default
(or previously set) values.
1. To change values, touch the button. A keyboard
2. Key in the new value, and press √.
3. To set a new average piece weight, press
4. A new screen appears saying: Place reference
5. This establishes a new reference weight with a
6. After following these instructions, and setting all
screen appears.
RECALCULATE APW.
weight on the pan. Press ACCEPT to continue.
sample. Alternatively, fill in values in the screens for
APW, samples and target.
values as desired, press RETURN TO APPLICATION.
0924 IH-4737