Bleeding The Hydraulic System - Pro-Point 8656316 Manuel D'utilisation

8656316
motor oil as they can damage the seals. Always purchase and use
products labeled Hydraulic Oil.

BLEEDING THE HYDRAULIC SYSTEM

Bleed excess air from the hydraulic system as follows:
1. Open the release valve (#P33).
2. Remove the oil filler screw (#P34). Fill the pump with
hydraulic fluid until it is full.
3. Wait 5 minutes for trapped air to rise to the surface.
4. Pump the handle (#43) for several full strokes to eliminate
any air in the system.
5. Check the oil filler hole and if necessary, top off with more
hydraulic oil.
6. Restore the oil filler screw and close the release valve.
7. Test the ram several times for proper operation before
putting it into use. Do not use the ram if it still does not
appear to be working properly. Have a qualified service
technician service or repair the hydraulic system.
CLEANING
Clean the outside of the press with a dry, clean and soft cloth.
LUBRICATION
Inspect and lubricate the tool when required. Only use a light oil.
Periodically lubricate all moving parts. Do not allow oil onto the
heel blocks or frame of the shop press.
STORAGE
When not in use, store the press in a dry location with ram
and piston fully retracted.
DISPOSAL
Recycle a tool damaged beyond repair at the appropriate facility.
Contact your local municipality for a list of disposal facilities or
by-laws for electronic devices, batteries, oil or other toxic liquids.
10
20 TON HYDRAULIC SHOP PRESS
For technical questions call 1-800-665-8685
V1.0