Publicité
3) Remove both ends of the choke link
w
204053*
4) Remove the starter/ flywheel cover
5) Prepare the engine for starting. See
208066
6) Pull up the lever 3 on the carburetor
e
204054
7)
8) Pull the rope slowly until resistance is
9) Give a strong pull straight out to
208072
5-7
rod 2.
after removing 3 bolts.
Disconnect the wire leads connected
the starter/ flywheel cover.
"STARTING ENGINE" for procedures.
Be sure the engine is in Neutral and
that the lanyard lock plate is attached
to the engine stop lanyard switch.
to operate the choke system when the
engine is cold.
After the engine starts, return the
lever to the original position.
Insert the knotted end of the emer-
gency starter rope into the notch in
the flywheel rotor and wind the rope
several turns clockwise.
felt.
crank and start the engine. Repeat if
necessary.
GB
Publicité
Chapitres
