Hobbytech REVOLT BX-10 3.0 Notice D'utilisation page 7

install battEriEs on transmittEr
A
- Remove the battery cover from the
transmitter by sliding it in the direction
of the arrow in the figure B
- Remove used batteries.
- Load new AA size batteries. Pay very
close attention to polarity markings
and reinsert accordingly (
- Slide the battery cover back onto
the case.
bind
A
C
Place model on a block to prevent wheels from touching the ground.
A
Turn on transmitter switch and the LED battery indicator will light up. If it blinks or doesn't light up, check polarities and battery power.
If the battery power is low, replace batteries with new ones.
B
Connect battery to ESC. Fix the wire correctly with the provided connectors.
C
Turn ON receiver switch.
D
You must check the signal of transmitter and receiver before you operating it at first.
Make sure TH Trim is on neutral, TH D/R is on maximum value (10), and ST in on NOR.
- With a tip, push on SWITCH receiver button during 3 seconds, then release : Red LED blinks, then lights. This means your
transmitter is correctly synchronized with your receiver.
.
C ).
B
B
D
C
7 7