Accessory Storage Assembly; Powerhead Assembly / Removal - Craftsman CMXEVBE176060 Guide D'utilisation

Accessory Storage Assembly (Fig. E)
1. Position the Accessory Storage onto the Powerhead
Assembly at the rear of the unit.
2. Align with the Three Holes of the Accessory Storage
with the Three Holes of the Powerhead Assembly.
Secure the Accessory Storage using the Three
#10 x 3/4" (19 mm) Screws, provided.
Fig. E
SP7092-1 12 & 16 GALLON.indb 7
Powerhead Assembly / Removal (Fig. F)
To Reattach Powerhead Assembly to Drum:
1. Line up the Detachable Blower Assembly with the Vac
Inlet Port located on the front of the Dust Drum.
NOTE: The Powerhead Assembly must be aligned with
Drum for proper attachment.
2. Place Powerhead Assembly on top of Drum so that
Drum Latches on Powerhead Assembly rest on Drum
Handles, as shown.
3. Press down on Drum Latches to secure Powerhead
Accessory
Assembly to Drum. Pull up slightly on Top Handle to
Storage
Screws (3)
ensure that Powerhead Assembly is attached to Dust
Drum.
To Remove the Powerhead Assembly from the Drum:
Lift up on the Two Latches and remove from Drum.
Accessory
Fig. F
Storage
Wet/Dry
Vac
Detachable
Blower
Handle
Drum
Latches (2)
Vac Port
Powerhead
Latches (2)
Drum
7
9/13/19 9:07 AM