Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Guidelines for Using Extension Cords
• If you are using an extension cord outdoors, be sure it is marked with the suffix "W-A" ("W" in
Canada) to indicate that it is acceptable for outdoor use.
• Be sure your extension cord is properly wired and in good electrical condition. Always replace a
damaged extension cord or have it repaired by a qualified person before using it.
• Protect your extension cords from sharp objects, excessive heat, and damp or wet areas.
Recommended Minimum Wire Gauge for Extension Cords (120 Volt)
Nameplate
Extension Cord Length
Amperes
25 Feet
(At Full Load)
0–2.0
18
2.1–3.4
18
3.5–5.0
18
5.1–7.0
18
7.1–12.0
18
12.1–16.0
14
16.1–20.0
12
SPECIFIC SAFETY RULES FOR OSCILLATING
TOOLS
WARNING:
(GAINED FROM REPEATED USE) REPLACE STRICT ADHERENCE TO
PRODUCT SAFETY RULES. If you use this tool unsafe or incorrectly, you can
suffer serious personal injury!
WARNING:
an operation where cutting tools may contact hidden wiring or its own cord.
Contact with a "live" wire will make exposed metal parts of the tool "live" and
shock the operator!
• Always wear safety glasses or goggles.
are not safety glasses.
• Hold the Oscillating Tool by its insulated gripping surfaces to avoid
electrical shock from unseen "live" wires.
• Always hold the tool firmly. DO not
• Check your work area for proper clearances before cutting.
avoid cutting into your workbench, the floor, etc.
• DO not cut nails or screws
purpose. Inspect your material before cutting
• Before switching on the tool,
• Do not use tool if switch does not turn it on or off.
controlled by the switch is dangerous and must be repaired.
• Wear cushioned protective gloves to minimize the vibration.
vibration may cause personal injury.
• Do not wet-sand with this tool.
cause electric shock and serious personal injury.
VS Multi-Purpose Oscillating Tool
Operator's Manual
50 Feet
75 Feet
18
18
18
16
14
12
10
DO NOT LET COMFORT OR FAMILIARITY WITH PRODUCT
Hold tool by insulated gripping surfaces when performing
unless you are using a blade specifically designed for this
100 Feet
18
18
18
16
16
14
14
12
12
10
10
10
8
8
Normal prescription eye or sunglasses
leave the tool running unless hand held.
.
be sure the blade is not contacting the work piece.
Water or moisture entering the motor housing can
GMT16V
150 Feet
200 Feet
16
16
14
14
12
12
12
10
8
8
8
6
6
6
This will
Any tool which can not be
Excessive
Publicité
Table des Matières
