Changing The Tool - Bosch GOP 12V-28 Professional Notice Originale

8 | English
To remove the battery (3), press the battery release button
(2) and pull the battery to the rear and out of the power tool.
Do not use force to do this.
Battery charge indicator
The three green LEDs on the battery charge indicator (6) in-
dicate the state of charge of the battery (3). The battery
charge indicator only lights up for five seconds after start-
up.
LED
Continuous lighting 3x green
Continuous lighting 2x green
Continuous lighting 1x green
Flashing light 1x green
Flashing light 3x green
If no LED lights up after switching the power tool on, then
the battery is defective and must be replaced.
The following table shows examples of application tools. You can find additional application tools in Bosch's extensive range of
accessories.
Application tool
AIZ 10 AB
Starlock
10 × 20 mm bi-
metal plunge cut
saw blade for wood
and metal
AIZ 32 EPC
Starlock
32 × 50 mm HCS
plunge cut saw
blade for wood
AIZ 32 APB
Starlock
32 × 50 mm bi-
metal plunge cut
saw blade for wood
and metal
AIZ 32 BSPB
Starlock
32 × 50 mm bi-
metal plunge cut
saw blade for hard-
wood
AIZ 32 AT/
AIZ 32 AIT
Starlock
32 × 40 mm
carbide plunge cut
saw blade for metal
1 609 92A 5YG | (21.08.2020)

Changing the tool

Wear protective gloves when changing tools. There is
u
a risk of injury when touching the application tools.
Selecting an application tool
Please observe the application tools intended for your power
tool.
Application tool
Capacity
≥2/3
≥1/3
<1/3
Reserve
Empty
Material Application
Softwood, soft plastics, Smaller separation and plunge cuts; delicate adjustment
gypsum, thin-walled alu- work in wood;
minium and non-ferrous Example: Cutting recess for cable, plunge cuts in gypsum
metal profiles, thin metal boards, resawing recesses for locks and fittings
sheets, non-hardened
nails and bolts
Softwood Splinter-free separation and plunge saw cuts thanks to
round sawing edge (Curved-Tec); also for sawing close to
the edge, in corners and difficult-to-access areas;
Example: Plunge cut for the installation of a ventilation
grille or recess for plug sockets
Composite materials Tear-free flush cuts and plunge cuts in wood, soft non-fer-
made from wood and soft rous metals and plastic thanks to round sawing edge
non-ferrous metals, un- (Curved-Tec);
hardened nails and Example: Recess for plug sockets and pipes, flush cuts
screws, pipes made from through unhardened nails and screws
non-ferrous metal and
profiles with small dimen-
sions
Hardwood, laminated Splinter-free separation and plunge cuts in coated boards
boards or hardwood thanks to round sawing edge (Curved-Tec),
Japan toothing specially suited for hardwood;
Example: Installation of skylights, recess for plug sockets
Hard ferrous metals, ex- Sawing extremely abrasive materials or hard ferrous
tremely abrasive materi- metals; long service life thanks to BOSCH carbide techno-
als, fibreglass, plaster- logy;
board, cement-bonded Example: Cutting of kitchen front covers, simple sawing
fibreboards, hardened through hardened nails and stainless steel
nails and screws
GOP 12V-28
Bosch Power Tools