Toshiba RAV-SM404SDT-E Manuel D'installation page 26

Masquer les pouces Voir aussi pour RAV-SM404SDT-E:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Slim Duct Type
Remote controller switch monitoring function
This function is available to call the service monitor mode from the remote controller during a test run to
acquire temperatures of sensors of the remote controller, indoor unit, and outdoor unit.
1. Push
The service monitor indicator lights up and the header indoor unit number is displayed first. CODE No.
2. Pushing TEMP.
the following table.)
3. Pushing
temperatures of indoor units and their outdoor unit in the control group are displayed.
4. Push
CODE No.
01
02
03
04
F3
25-EN
and
buttons simultaneously for at least 4 seconds to call the service monitor mode.
is also displayed.
buttons, select the number of sensor, etc. (CODE No.) to be monitored. (See
(left side of the button), select an indoor unit to be monitored. The sensor
button to return to the normal display.
4
Indoor unit data
Data name
Room temperature (remote controller)
Indoor unit intake air temperature (TA)
Indoor unit heat exchanger (coil)
temperature (TCJ)
Indoor unit heat exchanger (coil)
temperature (TC)
Indoor unit fan cumulative operating
hours (x1 h)
2
1
CODE No.
– 25 –
3
Outdoor unit data
Data name
Outdoor unit heat exchanger (coil)
60
temperature (TE)
61
Outside air temperature (TO)
Compressor discharge temperature
62
63
Compressor suction temperature (TS)
64
65
Heatsink temperature (THS)
6A
Operating current (x1/10)
Compressor cumulative operating
F1
hours (x100h)
Installation Manual
(TD)

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Rav-sm454sdt-eRav-sm564sdt-e

Table des Matières