How To Set Up Power Saving Mode - Toshiba RAV-SM404SDT-E Manuel D'installation

Slim Duct Type
Change of lighting time of
filter sign
According to the installation condition, the lighting
time of the filter sign (Notification of filter cleaning)
can be changed.
Follow to the basic operation procedure
1 2 3
→ → →
(
• For the CODE No. in Procedure
• For the [Set data] in Procedure
setup data of filter sign lighting time from the
following table.
Setup data
0000
0001
0002
0003
0004
To secure better effect of
heating
When it is difficult to obtain satisfactory heating
due to installation place of the indoor unit or
structure of the room, the detection temperature of
heating can be raised. Also use a circulator, etc.
to circulate heat air near the ceiling.
Follow to the basic operation procedure
1 2 3
→ → →
(
• For the CODE No. in Procedure
• For the set data in Procedure
data of shift value of detection temperature to
be set up from the table below.
Setup data
0000
0001
0002
0003
0004
0005
0006
4 5 6
→ →
).
3
, specify [01].
4
, select the
Filter sign lighting time
None
150H
2500H (At shipment from factory)
5000H
10000H
4 5 6
→ →
).
3
, specify [06].
4
, select the setup
Detection temp shift value
No shift
+1°C
+2°C (At shipment from factory)
+3°C
+4°C
+5°C
+6°C
How to set up power
saving mode
1. Push button for at least four seconds
when the air conditioner is not working.
flashes.
Indicates CODE No. "C2."
2. Select an indoor unit to be set by pushing
(left side of the button).
Each time you push the button, unit numbers
change as follows:
Unit No.
1-1
The fan of the selected unit runs.
3. Adjust the power save setting by pushing TIME
buttons.
Each push of the button changes the power
level by 1% within the range from 100% to 50%.
* The factory setting is 75%.
• This indication may not be true for types other
than 4-series outdoor unit.
4. Determine the setting by pushing
5. Push button to complete the setting.
– 24 –
Installation Manual
Unit No. Unit No.
1-2 1-3
Unit No.
1-4
Setting of power level in
power saving mode
button.
EN
24-EN