Toshiba RAV-SM404SDT-E Manuel D'installation page 13

Slim Duct Type
• After the check, the drain pump motor runs,
connecting the float switch connector.
(In case of check by pulling out the float switch
connector, be sure to return the connector to the
original position.)
Power
terminals
CN34
(RED)
Black
Heat insulating process
• After drain check, using the attached heat
insulator for drain connecting section, wrap the
flexible hose without clearance from the end of
the drain pipe connecting port of the indoor unit.
• Covering the attached heat insulator for drain
connecting section, wrap the drain pipe with
heat insulator (local supply) without clearance.
Flexible hose
Attached heat insulator Heat insulator to be
Single phase
220–240V
1 2
White
Red
Black
Pull out connector CN34 (Red)
from P.C. board.
Hose band
procured locally
Hard vinyl chloride pipe
– 12 –
Installation Manual
EN
12-EN