Operating The Dishwasher - Jenn-Air JDB9600CWS Instructions D'utilisation

Operating the Dishwasher

To avoid risk of injury, always use caution when opening the door during or following a wash cycle as hot water or
steam may escape. Do not fully open the door until water noises have stopped and steam has subsided.
Start the dishwasher
Open the door and press the [On/Off] button. The Auto cycle LED flashes.
1
Select the desired cycle and options.
2
Press [Start] and close the door to begin the cycle.
3
Cancel a cycle
Open the door just far enough to expose the control panel. Be careful of hot water that may splash out.
1
Press and hold the [Start] button for approximately 3 seconds until the display reads "0:01".
2
Close the door and wait about 1 minute while the dishwasher drains.
3
Open the door and press the [On/Off] button.
4
Interrupt a cycle
Open the door just far enough to expose the control panel. Be careful of hot water that may splash out.
1
Press the [On/Off] button to turn the unit off.
2
To resume the cycle, press the On/Off button and close the dishwasher door.
3
Setting the amount of rinse aid
The amount of rinse aid dispensed can be set from "r:00" to "r:06".
To change the setting:
Open the door and press the [On/Off] button.
1
Hold down the "A" button (see page 4) and press [Start] until the display indicates "H:00".
2
Release both buttons.
3
Press the "A" button until the display shows "r:05".
4
Press the "C" button to select the desired setting.
5
"r:00" = dispenser is OFF
"r:01" = lowest setting
"r:02" = low setting
"r:03" = medium setting
"r:04" = medium/high setting
"r:05" = high setting
"r:06" = highest setting
Press [Start] to save the setting and close the door.
6
Cycle Status Light
A LED illuminates the floor to indicate the unit is running. If the appliance is installed at eye-level, the LED is not visible.
To change the setting:
Open the door and press the [On/Off] button.
1
Hold down the "A" button (see page 4) and press [Start] until the display indicates "H:00".
2
Release both buttons.
3
Press the "A" button until the display shows "1:01".
4
Press the "C" button to switch between "1:01" = ON and "1:00" = OFF and press [Start] to save.
5
WARNING
13