Jenn-Air JDTSS245GX Instructions D'installation

FOR CUSTOM PANEL AND KICK PLATE ATTACHMENT
IMPORTANT: Before installing your dishwasher, please use this instruction sheet as a supplement to the installation instructions.
Custom Panel Models Only
Gather these additional tools and parts before starting
attachment of the custom panel. Read and follow the
instructions provided in this instruction sheet.
Additional Tools Needed:
/ " drill bit
3
■
32
Torx T15 screwdriver
® ®†
■
Additional Parts Supplied with Custom Panel Models:
4 – Plastic studs (attached to each other by runners)
■
4 – Short screws (10-16 hex-head screw)
■
4 – Long screws (8-18 Torx
■
1 – Template (located inside Use and Care Guide
■
bag assembly)
1 – Instruction sheet (located inside Use and Care
■
Guide bag assembly)
Custom tape packet (part number W10366978)
■
NOTE: The screws supplied are used for only
wooden panel. If the wooden panel is less than
thick, customer must purchase screws locally.
Make sure all these parts are included in the literature package.
If parts are not included, call 1-800-422-1230. In Canada,
call 1-800-807-6777.
®
† TORX and T15 are registered trademarks of Acument Intellectual Properties, LLC.
W10883998B
INSTALLATION INSTRUCTIONS
UNDERCOUNTER DISHWASHER
STAINLESS STEEL TUB
head screws)
®
/ " (19 mm) thick
3
4
/ " (19 mm)
3
4
Install Custom Panel
Custom panel dimensions
*This dimension is for 4" (102 mm) toekick. If the installation
needs a higher toekick, adjust the height of the wood panel
accordingly except on models with fan-assisted dry. Fan
models may have a duct at the bottom of the door that would
be exposed if you shorten the door panel for toekick heights
above 4" (102 mm). Toekick heights greater than 6" (152 mm)
are not recommended for this product.
Follow Steps Below:
A customer supplied door panel and handle (together) must
weigh no more than 16 lbs (7.3 kg) and must be made to
specific dimensions. It is recommended that a cabinetmaker cut
the customer panel because of the precise dimensions needed.
NOTES:
The handle for the custom panel is not included.
■
All mounting hardware supplied is for a
■
wood panel. If a thinner wood panel or materials other than
wood are used, it is the customer's responsibility to obtain the
proper length screws and adjust the pilot holes accordingly.
If a custom wooden kick plate
■
is to be installed over the
dishwashers' metal access
panel, the height must not
exceed 3" (76 mm) from
the bottom of the metal
access panel.
IMPORTANT: Use a moisture-
resistant sealer on both sides
and all edges of the panel and
any wooden kick plates to
avoid damage from moisture.
/ " (19 mm) thick
3
4
3"
(76.2 mm)