Jenn-Air JDTSS245GX Instructions D'installation page 3

4.
Attach plastic studs
Plastic studs attached
with 4 short screws
Visible side
Attach the 4 plastic studs to the wooden panel using the four
/ " hex-head (short) screws provided.
5
16
5.
Attach custom tape
Check custom tape alignment with metal door slots; verify tape
is right-side up and that the tape does not overhang the metal
door on the top, bottom, or side interfaces. Remove the backing
from the custom tape by pulling straight down on the liner. Align
the custom tape to the keyhole slots on the metal door (see the
previous illustration) and apply. Repeat steps for one side and
then the other.
NOTE: The adhesive on the tape is aggressive, so proper
alignment and attachment to the metal door needs to occur
on the first try.
6.
Attach custom panel
Align the studs on the custom wood panel to the keyhole
slots on the door assembly. Ensure that all 4 plastic studs are
engaged in the keyhole slots. Slide wood panel down until the
top surface of the wooden panel is flush with the top of the door.
7.
Align top edges of panel to door
Customer
supplied panel
Remove 2 short screws
and replace with long
screws provided.
Open the door and align top edges. Use tape to mark a
bit to gauge the hole depth of approximately 1
pilot holes into the top corners of the door, using hole in liner as
a guide.
Wooden panel
assembly
Align
top edges
Drill through
these holes.
/
3
32
1 / " (38 mm). Drill
2
" drill
3