Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
8.
Install custom panel
Customer
supplied panel
Using a Torx
T15
screwdriver, install two #8 x 1
®
®
screws in top corners to secure custom wood panel in place.
4
Align top
edges
Drill through
these holes.
1
/
"
3
8
screw
Remove 2 short screws
Remove the short screws (3rd from top) on either side of the
/
" (long)
inner door panel. Use tape to mark a
3
8
hole depth of approximately 1
using the door liner hole as a guide into the panel. Install the
2 remaining long screws.
9.
Remove the short screws
and replace with long
screws provided.
Align top
edges
Customer
supplied panel
/
" drill bit to gauge the
3
32
/
" (38 mm). Drill 2 pilot holes
1
2
Publicité
Table des Matières
