Delay Start; Extra Dry; Auto Power Off - Jenn-Air JDB9600CWS Instructions D'utilisation

Delay Start

You can delay the start of the cycle in one hour increments up to 24 hours.
To set delay start:
Open the door and press the [On/Off] button.
1
Press the [+] button until the display jumps to "h:01".
2
Press the [+] or [-] button until the displayed time corresponds with your requirements.
3
h:01 = 1 hour delay
h:24 = 24 hour delay
Press [Start] to activate delay start.
4
To cancel delay start:
Press the [+] or [-] button until "h:00" is indicated on the digital display.
1
Press [Start] to save setting and close the door.
2
Cycle Completion Signal
Open the door and press the [On/Off] button.
1
Hold down the "A" button (see page 4) and press [Start] until the display indicates "H:00".
2
Release both buttons.
3
Press the "A" button until the display shows "b:02".
4
Press the "C" button to increase or decrease the tone "b:00" = OFF and "b:03" = LOUDEST
5
Press [Start] to save setting and close the door.
6

Extra Dry

The final rinse uses a higher temperature which improves the drying results. The running time may increase
slightly.
To turn intensive drying on:
Open the door and press the [On/Off] button.
1
Hold down the "A" button (see page 4) and press [Start] until the display indicates "H:00".
2
Release both buttons.
3
Press the "A" button until the display shows "d:00".
4
Press the "C" button to turn intensive drying on or off. "d:01" = ON and "d:00" = OFF
5
Press [Start] to save setting and close the door.
6

Auto Power Off

To save energy, the dishwasher is turned off 1 minute after the wash cycle ends. This function can be
adjusted from P:00 to P:02.
To change the setting:
Open the door and press the [On/Off] button.
1
Hold down the "A" button and press [Start] until the display indicates "H:0x" (x can be any num ber).
2
Release both buttons.
3
Press the "A" button until the display indicates "P:0x".
4
Press the "C" button until the display corresponds with your requirements.
5
P:00 = dishwasher does not turn off automatically
P:01 = dishwasher turns off automatically after 1 minute
P:02 = dishwasher turns off automatically after 120 minutes (2 hours)
Press [Start] to save the setting and close the door.
6
14