Philips Digital Pocket Memo LFH 9600 Manuel De L'utilisateur page 13

Press the + or − buttons (5) to highlight the
3
and press the ENTER smart button (2b).
Press the + or − buttons to highlight the
4
TRAINING menu item and press the
(2b). The voice command setting must be activated in
SpeechExec or the software application of your system integrator
for this option to appear in the menu.
The first keyword is displayed. Press and hold the
5
button (2a) and say the keyword. Press the
training the current item and continue to the next.
The Digital Pocket Memo will prompt you to repeat the word.
6
Press and hold the VOICE
again. If the training is successful, the Digital Pocket Memo will
automatically advance to the next keyword. Repeat from step
until you have trained all keywords.
D Note: If you have configured Voice Command to use
alphanumeric characters the training procedure starts with with
numbers (0-9), followed by letters (A-Z), then special characters.
For recognition of letters, say the word for each letter, such as
"alpha" for A, "bravo" for B and so on.
E Tip: Voice recognition performance can be adversely affected by
background noise during training, or words that sound similar,
such as "four" and "door". The Digital Pocket Memo may prompt
you to repeat the training procedure to guarantee reliable voice
recognition.
5.3.2 Enter keywords using voice command
The 4-position slide switch (12) must be in the
1
Press and hold the VOICE
2
keyword recognition mode.
Say the keyword or the word for the next character. If the
3
word is recognized, the corresponding keyword or character is
displayed.
Repeat from step until you have entered all characters of the
4 3
keyword.
Release the VOICE smart button. The keyword is displayed
5
Press the OK smart button (2b) to accept the keyword and
6
assign it to the current recording, or repeat from step
modify the keyword.
D Note: A keyword can have a maximum of 15 characters. For
more than 7 characters, the character size will be reduced to fit
the display.
User manual
SETUP menu item
VOICE CMD
ENTER smart button
Philips
VOICE
+ button to skip
smart button and say the keyword
STOP position.
smart (2a) button to activate the
2
smart
5
to
1