GE RGRWT Manuel Du Propriétaire Et Instructions D'installation page 11

Control and Operating Functions (RAREC1A)
Control and Operating Functions (RAREC2A)
49-5000928 Rev. 0
If Switch #5 is ON (RV-C
Virtual T.Stat Method), an
RARES1A room sensor
kit will be required.
default fan speed
in HP Mode if GL or
if a "Y" signal is
required for HP
Mode.
NOTE: Only use
Heat Pump modes
with rooftop models
beginning with
GRHS or PLHS.
Enable Heat Pump
modes by switching
DIP switch #1 on
the rear of the
thermostat to "ON".
11