Assembly And Commissioning; Installation Requirements - Bosch PLS Manuel D'installation

Parking Lot Sensor | PLS
1 General description and intended use
The Parking Lot Sensor PLS with TPS110 sensor core is designed for detecting parked vehicles in parking lots. The
Parking Lot Sensor PLS with TPS110 sensor core is not designed for use in life-sustaining applications, safety-critical
applications or applications for which a malfunction could lead to bodily harm, death or severe property damage. Only
use the Parking Lot Sensor with components approved by BCDS. This user manual is valid for the Parking Lot Sensor
PLS with TPS110 sensor core by BCDS.

2 Assembly and commissioning

2.1 Installation requirements

Read carefully and keep the user manual for future reference.
Follow these instructions and all information.
⇒ The Customer must comply with all applicable laws and regulations for the installation and operation
of the Product, and if necessary, obtain necessary approvals. The Customer must take appropriate
measures to avoid injury of third parties, for example, by them tripping over the Product. Therefore,
the product should, for instance, not be installed on the sidewalk.
Before installing the sensors, make sure that the necessary infrastructure is working properly - make sure the
gateways are switched on, that a stable Internet connection has been established, and that there is a backend
connection. The backend, as well as the associated management software, must be functional. Make sure that all of
the required components (see Fig. 1 Parking Lot Sensor PLS with TPS110 sensor core), as well as the tools, are
ready.
Figure 1 Parking Lot Sensor PLS with TPS110 sensor core
© Bosch Connected Devices and Solutions GmbH 2020. All rights reserved, also regarding and disposal, exploitation, reproduction, editing,
distribution, as well as in the event of application for industrial property rights.
Warning
3 | 16
1 Cap
2 Screw
3 Core (sensor TPS110)
4 Base (sensor base)