Labeling Channels; Selecting Channels - Insignia NS-LCD26A Guide De L'utilisateur

Insignia NS-LCD26A LCD TV
3 Press or to select Manual Ch Set, then
press OK or
Set Menu.
4 Press or
channel, then press OK to add (displays
Viewable) or delete (displays Not Viewable)
the channel.
5 Press EXIT to return to watching the
television.
You can use the CH+/- buttons to cycle
among the viewable channels. Not viewable
channels are skipped.
Note
You can use the Manual Channel Set Menu to
select a channel you want to view.
Monitoring DTV signal strength
You can use the DTV signal strength monitor to
check how strong your DTV signal is, and then
determine if you need to adjust your antenna or
digital cable input. The higher the signal
strength, the less likely you are to experience
picture degradation.
To monitor DTV signal strength:
1 Press MENU.
2 Press or
press OK or
3 Press or
press OK or
strength monitor and see the quality of the
signal being received.
to open the Manual Channel
to navigate and select a
to select Setup menu, then
to access the submenu.
to select DTV Signal, then
to view the on-screen signal
www.insignia-products.com

Labeling channels

If a channel is not already labeled, you can label
the channel so you know what channel you are
watching.
Note
If a channel label is provided on the signal from
the broadcasting station, the television displays
the short name for the DTV channel, even if you
didn't set up a label for that channel.
To label your channels:
1 Press MENU.
2 Press or
press OK or
3 Press or
then press OK or
Labels Menu.
4 Within the menu, press
highlight or cursor. Press
the channel number, or select a character.
Press OK to return to the previous menu.
5 Press EXIT to return to watching the
television.

Selecting channels

You can use one of three methods to select a
channel:
• Use the number pad
• Use the CH+ and CH- buttons
• Use the previous channel
Using the number pad
To go to a specific channel number:
• Press the number buttons (0-9) and the
dash (-) button, then wait for the television
to change channels, or press OK to go
immediately to that channel.
For example, if you want to select channel
8-3, press 8-3 on the remote control. (Make
sure that you press the buttons within three
seconds of each other, or the channel won't
be entered correctly.)
Note
In some situations, virtual channel numbers do not
correspond to physical frequencies.
to select Setup menu, then
to access the submenu.
to select Channel Labels,
to view the Channel
or to move the
or to select
button
13