Operation; Putting Into Storage; Cleaning - Gardena 1490 Mode D'emploi

➔ ➔
Outlet side
(pressure hose)

4. Operation

The pump is self-priming. If it does not start pumping within 12 seconds,
switch it off immediately (see section 7 : Troubleshooting).
1. Immerse the suction hose into water.
2. Open the outlet side (open valve if necessary).
3. Check that the drill rotates clockwise (corres-
ponding with the direction shown by the arrows
on the side of the drill).
4. Plug in the drill.
5. Switch on the drill at maximum speed (max. 3,400 r.p.m.).
The pump starts draining the water.
6. Once it has finished draining, the pump output can be regulated by the drill
speed.
The pump should not operate against a closed outlet side for too long a
period. Once all the water has been drained, switch off the drill immediately.

5. Putting into Storage

Storage :
Keep the appliance stored out of the reach of children.
1. Unplug the drill.
2. Disconnect the suction and pressure hose.
3. Remove the pump from the drill chuck.
4. Store the pump in a dry, frost-proof location.
Disposal :
The appliance may be disposed of in the normal household waste.

6. Cleaning

1. Unplug the drill.
2. After every use or if it is soiled, clean the pump out thoroughly with water.
➔
Input side
(suction hose)
11