Assembly; Operation - Gardena 9000CLEAR Mode D'emploi

2. ASSEMBLY

DANGER! Risk of injury!
Injury when the product starts accidentally.
v Disconnect the product from the mains before
you assemble the product.
Connection possibilities of the connection nipple
[ Fig. A1 ]:
The hose can be connected via the connection nipple
with different hose diameters or the GARDENA Connection
System.
Large hose diameter
GARDENA Connection System /
Art. 9046: Medium hose diameter
Small hose diameter
When using the largest hose diameter, the pump has the
maximum delivery capacity.
Pump Art. 9030
Art. 9032
Art. 9040
Small hose
25 mm (1")
diameter
Art. GARDENA Art. 7193
Hose Clamp
Medium hose GARDENA
diameter Connection
System G 1"
Art. GARDENA
Hose Clamp
Large hose 38 mm (1 1/2")
diameter
Art. GARDENA Art. 7195
Hose Clamp
When using the 38 mm (1 1/2") hose, we recommend the
GARDENA Flat Hose Set Art. 5005 with 10 m hose and
hose clamp.
* For Art. 9042 an additional connection nipple
1 1/4" hoses is supplied.
To connect the hose via the connection nipple:
1. When using the large diameter hose, cut off the
connection nipple (4)

3. OPERATION

DANGER! Risk of injury!
Injury when the product starts accidentally.
v Disconnect the product from the mains before
you connect, adjust or transport the product.
9030-20.960.01.indb 13
(a)
Detach nipple at
[ Fig. A2 ]
(b)
Detach nipple at
[ Fig. A3 ]
Do not detach nipple
[ Fig. A4 ]
Art. 9042 Art. 9046
25 mm (1") 32 mm (1 1/4")
Art. 7193 Art. 7194
GARDENA 38 mm (1 1/2")
Connection
System G 1"
32 mm (1 1/4") *
Art. 7194 Art. 7195
38 mm (1 1/2") 51 mm (2")
Art. 7195 Art. 7196
ß
for
4a
at (a) .
2. Only for Art. 9046: When using the medium hose
diameter, cut off the connection nipple
3. Push the hose onto the connection nipple
4. Fix the hose to the connection nipple
a GARDENA Hose Clamp.
Connect hose via the GARDENA Connection System:
(4)
With 25000DIRT (Art. 9046) the hose cannot be connected
via the connection nipple
tion System.
19 mm (3/4") / 15 mm (5/8") and 13 mm (1/2") hoses can
be connected via the GARDENA Connection System.
We do not recommend hose diameters smaller than
25 mm (1"), otherwise there will be a significant reduction
in the output of the delivery rate.
Hose diameter Pump connection
13 mm (1/2") GARDENA Pump Connection Set
15 mm (5/8") GARDENA Pump Connection Set
19 mm (3/4") GARDENA Pump Connection Set
1. Cut off the connection nipple
2. Connect the hose to the connection nipple
appropriate GARDENA Connection System.
To assemble the pump connection [ Fig. A5 ]:
DANGER! Risk of injury!
Cut injury by the impeller.
v Operate the pump only with the elbow
connector.
The hose can be easily connected and disconnected using
(2)
the locking devices
1. Screw the elbow connector
until it stops. (If the hose is to be installed horizontally,
the elbow connector
to half a turn.)
2. Only for Art. 9042 / 9046: Screw the connection
piece (3) into the connection nipple
3. Push the connection nipple
(1)
elbow connector
and visibly.
The hose is securely connected to the pump.
To pump water:
If the pump cannot be immersed via the handle, the
pump must always be immersed via a rope. Attach
the rope by pulling it through the eyelets provided and
knotting it. Minimum immersion depth during initial
operation see 7. TECHNICAL DATA.
(4) (b)
at .
(4)
.
(4)
e. g. with
(4)
with the GARDENA Connec-
Art. 1750
Art. 1750
Art. 1752
(4) (b)
at .
(4)
via the
(1)
on the elbow connector .
(1)
clockwise into the pump
(1)
can be screwed out again up
(4) .
(4)
of the hose into the
until it stops and it engages audibly
13
18.09.20 12:48